��������

�������� College of Engineering and Computing – December 2024 Publications: 

•  L. D. Doucette, M. Greenslit, and M. P. Da Cunha, “Nuclear irradiation and characterization of Langasite SAWR sensors up to 800°C,” IEEE Trans. Ultrason., Ferroelectr., Frequency Control, doi: 10.1109/TUFFC.2024.3520421.

• I. Khiyara, B. Sidaway, and B. Hejrati, “Utilizing rhythmic haptic cueing in arm swing training to improve gait speed among older adults,” Ann. Biomed. Eng., 2024. [Online]. Available: .

• J. T. Gayton and J. L. Lapp, “Evaluation of theoretical models for anisotropic effective thermal conductivity in continuous fiber-reinforced thermoplastic laminates,” Int. J. Numer. Methods Heat Fluid Flow, vol. ahead-of-print, no. ahead-of-print, 2024. [Online]. Available: .

• J. C. Haller Jr., J. C. Clark, J. T. Gayton, M. S. Hunter, A. P. Schanck, C. A. Sheltra, W. G. Davids, R. A. Lopez-Anido, and J. L. Lapp, “Isonovel field-manufacturing methods for long-fiber thermoplastic composites,” SAMPE J., vol. 61, no. 1, pp. 30, 2025. [Online]. Available: .

•  M. Blaszkiewicz, L. Caron, B. Villinski, J. Passarelli, J. M. Towne, N. M. Story, E. Merchant, F. Khan, N. Emanetoglu, L. Kass, R. L. Smith, and K. L. Townsend, “Transdermal electrophysiological recordings of diet-induced small fiber peripheral neuropathy using a needle electrode array in mice and man,” Front. Bioeng. Biotechnol., vol. 12, 2024. [Online]. Available: .

• P. A. Díaz, L. Basti, I. Pérez-Santos, C. Schwerter, O. Artal, S. A. Rosales, L. Ross, R. Garreaud, C. Conca, G. Álvarez, Z. L. Fleming, F. Villanueva, M. Díaz, G. Mancilla-Gutiérrez, R. Altamirano, C. Rodríguez-Villegas, P. Urrutia, G. Urrutia, P. Linford, T. Acuña-Ruz, and R. I. Figueroa, “The risk of high-biomass HABs: Triggers and dynamics of a non-toxic bloom of Prorocentrum micans in Chilean Patagonia,” Sci. Total Environ., vol. 958, 2025, Art. no. 178140. [Online]. Available: .

•  M. Raheem, C. P. Tripp, and M. Tajvidi, “Oil and grease-resistant molded fiber containers produced by partial substitution of wood pulp with wood particles enabled by cellulose nanofibrils,” Cellulose, 2024. [Online]. Available: .

• D. Neivandt, C. Eme, and A. Cline, “Preserving the nano-scale morphology of cellulose nanofiber via drying under high shear conditions,” Phys. Sci. – Article, Dec. 3, 2024. [Online]. Available: .

• G. Bernhardt, L. Doucette, E. Khmeleva, N. Emanetoglu, and M. P. da Cunha, “Passively cooled BiTe thermoelectric generator for operation in harsh environments,” Frontier Institute for Research in Sensor Technologies (FIRST), University of ��������, Orono, ME, USA, Nov. 28, 2024. [Online]. Available: .

• M. Choudhary, W. Wang, K. Mensah, S. M. Mukhopadhyay, and O. G. Apul, “Disruption of the conjugated π-electron system of graphene oxides diminishes their microwave reactivity,” Langmuir, vol. 40, no. 51, pp. 26824–26834, 2024. [Online]. Available: .

• L. O’Brien, L. Li, W. Friess, J. Snow, B. Herzog, and S. O’Neill, “Review of bio-based wood fiber insulation for building envelopes: Characteristics and performance assessment,” Energy Build., vol. 328, 2025, 115114. [Online]. Available: .

• A. S. Verma, C.-Y. Wu, M. A. Díaz, and J. J. E. Teuwen, “Analyzing rain erosion using a Pulsating Jet Erosion Tester (PJET): Effect of droplet impact frequencies and dry intervals on incubation times,” Wear, vol. 562–563, 2025, 205614. [Online]. Available: .

• D. van Binsbergen et al., “Modeling of rain-induced erosion of wind turbine blades within an offshore wind cluster,” J. Phys.: Conf. Ser., vol. 2875, no. 1, 2024, 012040. [Online]. Available: .